Hyper-Accelerated Corrosion Found In Doomed Tanker

Wednesday, April 11, 2001
Investigators hoping to find the cause of why an assumed healthy ship developed a near fatal deckplate crack - an incident which led to a 39-day saga which will serve as an impetus for change in the rules of the way ships in distress are handled - have issued a preliminary report. Following an exhaustive inspection and analysis of the damaged product tanker Castor, the Cyprus Department of Merchant Shipping and ABS have jointly announced preliminary findings that point to hyper-accelerated corrosion as the probable principal cause behind the structural failure. "The Castor has become a floating laboratory which is providing us with some surprising findings," said ABS Chairman and CEO Frank J. Iarossi. "If these initial conclusions hold up, there will be significant implications for class and possibly wider implications for the manner in which the new generation of double hulled tankers should be constructed and maintained." A formal report into the casualty will not be issued by the Cypriot authorities and by ABS until the conclusion of detailed laboratory testing of steel samples cut from the damaged section of the tanker. "It will take some time to scientifically verify that our interpretation of events is correct," said Iarossi. "The Castor represents an unprecedented level of cooperation between the class society and the Flag State involved in a casualty," said Captain Andreas Constantinou, Senior Marine Surveyor for the Cyprus Department of Merchant Shipping. "In my experience, never before has class and the Flag State worked so closely to understand the causes of a casualty and to develop necessary changes in the regulatory requirements." The 600 tons of steel, primarily in the deck plating and underdeck longitudinals, that was renewed on the Castor at Special Survey in late 1997 has provided the key to understanding what transpired in the interim. "Although further testing is still being undertaken, our gaugings indicate that sections of this steel have already wasted by as much as 30 percent," said Iarossi. "This indicates an annual corrosion rate of as much as 1.5 mm compared to normal rates of about 0.1 mm or less." The critical element, according to the preliminary findings, is the presence, and absence of coatings. "The original steel had been coated," explained ABS Chief Surveyor Gus Bourneuf. "This coating had begun to break down with age. At the fourth special survey, the new steel was not coated. There were no sacrificial anodes in the tanks so the uncoated steel in the underdeck area acted as the anode with the partially corroded, original steel providing the principal point of attack." According to an independent corrosion expert, brought in by ABS to analyze the condition of the ship, three other elements are considered likely to have contributed to the rapid deterioration. The vessel had been engaged in the gasoline trades, the most corrosive of all oil products. The critical no. 4 tanks were used for ballast purposes, introducing salt water into the chemical equation. And the vessel had been trading into hot areas, such as West Africa, greatly raising the ambient temperatures in the ullage spaces and creating a fertile environment for the corrosive action. "Given the scantlings applicable to this size of ship, the loss of nearly 5 mm of the new steel in just over three years of trading represents a very high percentage loss of section," said Bourneuf. "The loss of section of the uncoated steel that was not replaced was clearly greater. It is reasonable to conclude that this loss of strength in this critical area of the vessel may have contributed to the buckling, and subsequent cracking of the deck plating in the severe weather conditions encountered on passage." Iarossi stressed that the focus of the on-going investigation will be on necessary remedial steps that need to be taken by ABS, recommended to IACS and, if necessary, proposed at IMO. "Once we have definitive conclusions to the investigations, Cyprus will raise the need for any changes in IMO requirements at the governmental level," Constantinou confirmed. "As more information is obtained from the on-going metallurgical and corrosion studies, we will develop and distribute to our colleagues in IACS and to the industry our specific recommendations for changes to Rule requirements," said Iarossi. "It must be remembered that the Castor had met all class requirements when the major steel replacement was completed, and had remained in class with no outstandings" he added. "We have always felt that the Rules are sufficiently conservative for any operational environment. Although it must be emphasized that the Castor was structurally sound, it did not sink, it did not lose any cargo or cause any pollution, and no one was injured or lost their life, if there are shortcomings in the requirements we need to rectify that, and do so quickly." Castor is a steel single hull product carrier vessel with a gross tonnage of 18,565 and a deadweight of 31,068 metric tons, built at the Busan shipyard of the Korea Shipbuilding & Engineering Corporation. The ship suffered heavy weather damage while on passage from Romania to Nigeria on December 30, 2000. It was denied a sheltered area to tranship the cargo of 29,500 tons of unleaded gasoline by seven coastal states in the Mediterranean area. The vessel was towed over 1000 miles, through repeated storms while in a damaged condition until a successful salvage of the cargo was completed at sea some 39 days later. The vessel is currently undergoing inspection and repair in Piraeus.
Maritime Reporter June 2014 Digital Edition
FREE Maritime Reporter Subscription
Latest Maritime News    rss feeds

Workboats

Pumps Reach Sinking Shrimper Just in Time

A commercial fishing vessel from Brownsville is slowly making its way back to port, thanks to some quick actions by its crew and Coast Guard units, informs the US Coastguard,

North Sea Atlantic Joins the Technip fleet

On Saturday July 26, 2014, a ceremony was held in Bergen to officially name the latest new subsea construction vessel to join the Technip fleet, the North Sea Atlantic.

HydroComp to Hold Propeller 'Mini-Workshop'

A special version of HydroComp's intensive Propeller Workshops will be brought to Tampa before the start of IBEX 2014.   The Mini-Workshop is a special version

 
 
Naval Architecture Navigation Offshore Oil Pipelines Pod Propulsion Salvage Ship Electronics Ship Simulators Sonar Winch
rss | archive | history | articles | privacy | terms and conditions | contributors | top maritime news | about us | copyright | maritime magazines
maritime security news | shipbuilding news | maritime industry | shipping news | maritime reporting | workboats news | ship design | maritime business

Time taken: 0.1709 sec (6 req/sec)