Eymard Marine put its latest pushboat in the water last August from its Harvey, La. yard. The 70 x 28 x 9.5-ft. boat was finished out alongside the dock for a September delivery. Named the Kallie C. Eymard, the vessel features three Cummins KTA19 M3 engines producing a total of 1,800 hp. Each engine turns into a Twin Disc 5202 gear with a 6:1 ratio and turning 66 x 54-in. four-blade stainless Coolidge propellers from Jefferson Wheel. According to Gary Eymard, due to rising fuel prices, the center engine has been set up with a shaft brake so that if a job only required 1,200 hp, one engine can be shutdown to save on both hours and fuel. Deck winches are a pair of Nabrico 40 ton electric over hydraulics loaded. Electrical power is provided by two Cummins 4B3.9 powered 35 kW gensets.