Three Repairs Completed on Cargo Vessel in Gabon
Hydrex diver-technicians carried out three separate repairs on a 118-meter general cargo vessel while the ship was at anchorage off the coast of Port Gentil, Gabon. These on-site repairs allowed the customer to save precious time and money.
The entire operation was supervised and coordinated by the Hydrex team leader from inside a monitoring station.
A detailed inspection of both the outside and inside of the bulbous bow revealed that the entire area had been damaged. The bottom of the bow was heavily indented. This had caused serious deformation of the structural framework in the forepeak of the vessel. There were also several cracks and small holes in the hull plating.
The Hydrex team installed 14 larger doubler plates, as well as many smaller ones, to close off the damaged area from the rest of the vessel and prevent leaks. Three additional frames were also installed to reinforce the bulkhead and to make sure that the vessel could sail safely. Finally, crack arrests were drilled to prevent the cracks from spreading any further.
To repair holes in the bottom plating of the cargo hold, the Hydrex diver-technicians installed two insert plates, measuring 600 x 600 mm and 500 x 450 mm. After they had cut away the damaged areas, they prepared the edges of both holes. Next, the new inserts were positioned and kept in place with screw docks. A full penetration weld was then used to secure the plates, finishing the second part of the operation.
Simultaneously with the other two repairs, the Hydrex team also replaced plating of the damaged port side brackets of one of the large container guiding frames in the cargo hold. Pins were pushed through this plating and into tubes in the hold wall to secure the frames. This allows the crew to reposition the frames or remove them according to the requirements of the cargo transported. The Hydrex technicians cut away the old plating on the frames, as well as on the hold wall, and installed new plating with full penetration welds. They also replaced the old worn tubes in the cargo hold wall and the securing pins with new ones.